b'Control Units AcessoriesControl Unit for Autonomous Gas Springs High Pressure Nitrogen Regulator PR-1The UC 101.1 control unit will allow for charging for all gas springs and also pressure control for gas springs by means of a\x1a Single stage construction with 2 gaugesG1/8 charging port. During pressure-checking operations, there is an approximate 10% gas loss.\x1a The nitrogen regulator with safety relief valve is set for \x1a FOR GAS SPRING PRESSURE MONITORING BY MEANS OF A G1/8 CHARGING PORT safe operation\x1a FOR ALL GAS SPRINGS (UC-103 NECESSARY) Pressure gauge MP-1Discharging valve VD-1Thread type Quick coupling ERMHow to orderNeedle PR-1 - 2Code Thread typeG1/8 connector PR-1 (SPAIN) TECHNICAL INFORMATIONThread type to N2 bottle - M21,7x1,814 right Max. Inlet pressure 315 BarPR-2 (GERMANY) Max. delivery pressure 210 BarM6-C adapter Weight 2 KgM6-A adapter Charging and Checking Stand SampleM8 adapterInstructions for use of UC-101.1 as a Charging UnitFor gas springs with a G1/8 charging portStep 1: Unscrew the G1/8spindle half-way until the needle goes in fully.Step 2: Screw the gas spring on to the G1/8connector.For gas springs with a M6 or M8 threadStep 1: Screw an M6-A or M8 adaptor (as necessary) ontthe G1/8 connector thread. If necessary, also screw in a M6-B orN 2M6-C adaptor to the M6-A adaptor. UC-103 Step 2: Screw the gas spring in the charging tool on to the M6-A or M6-B or M6-C or M8 connector (as necessary).GAS SPRINGStep 3: Plug the UC-103 charging hose into the quick coupling fitting.Step 4: Slowly open the valve in the UC-103 charging hose untilUC-101 the desired pressure is attained in the pressure gauge. Close the valve.Step 5: The gas spring valve closes automatically. In order to evacuate remaining pressure in the charging unit, turn the screw of the waste valve slowly until the remaining pressure is released (when the pressure gauge shows 0 bar). Turn the waste valve screw back to its initial position. For further information, please contact our technical department. Step 6: Take the gas spring out of the tool.130 131'