b'Control Panels Control PanelsControl Panel for Eco-Manifold Plate, Side outlet,P-110 M Pressure Switch PS-160 20 Seal3439301 609227(x2) 6510.5 74G1/8"(x4) 72 SW27G1/4" P 2 41. Discharge VD-1 valve 1Ra 0.8 2. Quick coupling for charging ERM3. Pressure MP-1 gaugeTECHNICAL INFORMATION4 Work field 50 - 200 BarWorking temperature -30C+100COperation voltage 4A / 250VMini control panel with a side outlet for manifold plates: this device is used for the permanent control of gas springsOperating frecuency 200min -1interconnected by means of a manifold plate. It is equipped with a quick-fit socket for gas charging and a discharging valveMechanical life 10 6operating cyclesfor decompression. Pressure gauge range is from 0 to 400 Bar IP protection IP 65Control Panel for Eco-Manifold Plate, Rear outlet,P-110 CE Pressure Switch PS-261.5 27M12x13 G1/8"(x4)Seal1 4.5 1 pnp 9.6to93.5 18.97(x2) 500mA 2 1 32VDC2 pnp62 5SET 3 432 2500mA32 10.5 20 RESET72 3 715 61137.5SW27Ra 0.8 \x1a LOW COST PRESSURE SWITCH FOR PRESSURE 4 CONTROL IN LINKED GAS SPRINGS SYSTEM\x1a EASY TO CONNECT TO THE CONTROL PANEL1. Discharge VD-1 valve M52. Quick coupling for charging ERM 1/4" NPT4 3. Pressure MP-1 gauge TECHNICAL INFORMATION Locking ring Setting ring (manually adjustable after unlocking) Work field 0 - 400 Bar Green LED: supply voltage OK Working temperature -25C+80CYellow LED: Set1 value reached, output = ON Operation voltage 9.6 to 32 VDC,25mAOperating frecuency 100HzMini control panel with a rear outlet for manifold plates: this device is used for the permanent control of gas springs Tightening torque 25Nm Mechanical life 50 6operating cyclesinterconnected by means of a manifold plate. It is equipped with a quick-fit socket for gas charging and a dischargingIP protection IP 67valve for decompression. Pressure gauge range is from 0 to 400 Bar. NOTE: protective cover and angled electrical connector (5m cable) included Wiring terminations 4 pin M12electrical connector126 127'