b'HYDROCAMH-1 READYPump SpecificationsHYDROCAM H-1 PumpREADY recommendsusingonly a premium grade of M Ghydraulic oil. D5 The H-1 pump is available insix standard sizes. Each pump M) x (4 in 0.079has four ports to activate up to mm 0.3 in 0.012 G Gmm 0.2four identical H-2 units. The+ + + +quantity, size, and stroke length ofthe H-2 units hosed to each 1 Sq. 2 Sq.pump determines the size andoil volume of the pump needed. GPumps can be up to six feetaway from H-2 units. This allowsyou to free up critical die spaceDriverand balance die loads. (not supplied) D4Piston Rod Travel 5 HtPiston rod travel controls oilvolume going to the H-2 unit(s). Approach Stroke D2 Our selection chart on page 5 3 Ht 4 Ht Volume Strokeprovides the dimension for you. D6 See page 10 for this calculation.Stroke GaugeOptional Stroke Gauge Ring RingUsed as a visual gauge to assistmm 0.5 in 0.020 Piston Dia. D3in set-up. Ring is located on topD1+ +of pump body and made to theappropriate height based upon1 Ht Supply (4) Oil piston rod travel calculation. PortsThis stroke gauge ring is not a G Gstop block and should be used for 2 Ht Gset-up purposes only. See page 10for this calculation.Mounting Suggestions: The H-1 pumps piston rod Required position of H-1 as compared to H-2must be up and perpendicularto the ram. H-1 pump must be located ator above the H-2 units eleva-tion. Locate the H-1 anywhere in the die under the ram that provides ram balance and simple hose access to the H-2 unit(s). Locate the H-1 pump within six feet of the H-2 unit(s). Always use stop blocks. Die storage blocks are Model H dimensionrecommended. HYDROCAM H1-5 21 mm(0.83 in)Never store pump with piston HYDROCAM H1-8 25 mm(0.98 in) rod depressed or upside HYDROCAM H1-13 25 mm(0.98 in) down. HYDROCAM H1-20 25 mm(0.98 in)NOTE: READY understands that a fewHYDROCAM H1-40 30 mm(1.18 in)applications will exceed this guide.HYDROCAM H1-66 40 mm(1.57 in)Contact your READY representative for application support.8'