b'HYDROCAMREADYAccessories (cont.)Standard System Fittings - HydraulicBSPP Male Straight Connector BSPP Male 90 ConnectorG-1/4:READY Part # RT84F40MX-S G-3/8:READY Part # RT8F40MX-S READY Part # RT4C40MX-S READY Part # RT8C40MX-S35 36 11 22.6 19 31.89.5 16.7 9.5 16.726 6.3 7/16-20 37 9.5 3/4-1614 22G-1/4 3/4-16 G-3/8 3/4-16 G-1/8 G-3/819 22BSPP Male 45 Elbow 45 Swivel Nut Elbow 90 Swivel Nut ElbowREADY Part # RT8V40MX-S READY Part # RT8V6X-S READY Part # RT8C6X-S24.92519 31.8 1021.8 10 24.1193/4-16 1.383/4-16 32.5 19 3/4-169.533 22 22 3/4-16 10 2210 3/4-16G-3/8Flexible High Pressure Hoses and ConnectorsMinimize the number of fittings in the hose system.Do not use a hose system that involves a fittingto fittingto fitting series of connections.Hose each H-2 unit to an H-1 pump with its own hose. Do not hose in series. Provide simpleaccess for hose routing.Provide additional hose length to ensure appropriate radius and safe routing. Avoid highspots in the oil hose route that will trap and create air pockets.Hose to Connect H-1 to H-2Hose Hose Max. BurstMin Thread A H W BOperatingPart No. Pressure Pressure BendI.D. O.D. MPa / psi MPa / psi Radius Size Hex Hexmm 12 25 41.5 166 230 - 66 21 22 36RT701810670-(*) inch 0.50 0.97 6000 24,000 9 3/4-16 2.60 13/16 7/8 1.42* Standard hose lengths are 3 or 6. Specify custom lengths if needed. All hose and connectors are available individually, as assemblies, or in bulk upon request.READY Hand Pump of 1.8 Litre Capacity (250 bar maximum output)Reduce HYDROCAM Set-up Time By Using This Hand Pump. This Oil HandPump Can Be Used for Three Different Purposes: Hand pump with hoseand adapter fittings1. Directly connected to the H-2 unit, it moves thepiston to allow the toolmaker to align punch and 1 2 3die within the tool.2. Filling the H-1 pump when the system is in the tool.3. Filling the oil/nitrogen accumulator if using oil returnoption. Extending H-2 piston rod Filling oil drive system Filling oil return system18'