b'HYDROCAM Design & READYInstall. Guide (cont.)Design and Installation Guide(Continued)Connecting the H1 Pump, H2 Piercing/FormingUnit(s) and Nitrogen Return Control Panel. See Wrongpage 8.1. Minimize the number of fittings in the hose system.2. Do not use a hose system that involves a fitting - tofitting - to fitting series of connections.3. Hose each identical H2 unit to a H1 Pump with itsown hose. Do not hose in series. Provide simple accessfor hose routing. Use only approved hose and fittings.4. Provide additional hose length to ensure appropriateradius and safe routing. Avoid high spots in the oil Righthose route that will trap and createair pockets.5. Maximum hose length is 2 meters (six feet). Do notsubstitute the supplied hydraulic hose with a smalleror lighter duty hose.6. Rotating the H1 Pump 45 may simplify hose routing.7. Avoid turning fittings. If a hose turn requires a turningfitting, select a 45 fitting as a first choice and a 90fitting second. Use only BSPP-style fittings.Required position of H1 as compared to H2 See above for proper positioning of the H1 Pump.Standard HYDROCAMsystems operate using a simplehydraulic driven extension with a nitrogen return and require noSight Gauge special conditions or procedures to operate them.DO NOT SUBSTITUTE ANY COMPONENT IN THIS SYSTEM!IMPROPER SUBSTITUTIONS MAY RESULT IN PERFORMANCEPROBLEMS AND/OR SAFETY HAZARDS.USE ONLY A PREMIUM GRADE HYDRAULIC OIL.As with any air, hydraulic or nitrogen cylinder, neither the H1Pump nor the H2 unit is designed to withstand side-thrust forces.Nitrogen Inlet Port Properly guiding the tool and cam station will limit damage to theNOTE: We understand that a few applications will exceed this guide. cylinders and increase seal life.Contact your representative for application support. THE MOST COMMON HYDROCAMOPERATING PROBLEM ISAIR CAUGHT IN THEHOSE SYSTEM.ENSURE THAT YOUModel H dimension HAVE PROPERLY LOCATED THE H1 PUMP, AVOIDED HIGHHYDROCAM H1-5 21 mm(0.83 in)SPOTS IN THE HOSE SYSTEM AND BLED THESYSTEM OF AIR.HYDROCAM H1-8 25 mm(0.98 in) Complete engineering assistance, seminars and service supportHYDROCAM H1-13 25 mm(0.98 in)are available should a need arise for any of our full line of metalHYDROCAM H1-20 25 mm(0.98 in)forming products. Contact your representative for details.HYDROCAM H1-40 30 mm(1.18 in) HYDROCAM H1-66 40 mm(1.57 in) 14'