b'Ready Bender Concept Sketches 3-4-13_2207 Ready3/21/138:25 AMPage 10READYREADY Bender CB8 Concept Sketch READY BenderCB8 has two CB5 bends where the front of the saddle is shorter thanstandard. Note: CB8 bends will most likely need to run off of a pad. This is to maintainrocker retention in the saddle. CB8 benders can also be interlaced. Max tonnage ReadyBender application.CB = Classified Bend #PT = Part Material ThicknessPT PL PL = Part Length (bent leg)PAPR 1 PR 2 PA = Part Angle (degrees of bend)PH PH = Part Height (bent leg)PC PR = Part RadiusCB8 PC = Part Channel (inside)Hat Bend K= see catalogIncl. Angle = Included Angle9'