b'Ready Bender Concept Sketches 3-4-13_2207 Ready3/21/138:25 AMPage 11READYREADY Bender CB13 Concept Sketch (large radius) READY Bender CB13 - the bend is a Larger Radius bend when the inside bend radius READY BenderCB13 - the bend is a CB13 Large radius bend when the insidebecomes too large to use the rocker diameter designated by the material thickness. bend radius becomes too large to use the rocker diameter designated by the materialExtra overbend will be needed to end up with the proper bend angle. Due to addition-thickness.Extra overbend will be needed to end up with the proper bend angle.al springback, Anvil Radius may need to be smaller than final Part Radius (PA).CB = Classified Bend #PT = Part Material ThicknessPT PL PL = Part Length (bent leg)PR PA PA = Part Angle (degrees of bend)PH PH = Part Height (bent leg)PR = Part RadiusCB13 PC = Part Channel (inside)Large Radius Bend K= see catalogIncl. Angle = Included Angle10'