b'1227 Ready:0476 GPB Catalog8/2/113:00 PMPage 6Custom Four PostDie SetsCustom, Four PostAll Steel Die SetsFour Post - Type 4PRight front pin offset 1/8.When ordering custom, all steel die sets, specify:1. This table shows accepted design shank is always located in middle of both Adimensions. Any or all of these dimensions, and B dimensions. For safety reasons, wehowever, can be changed to conform to supply only threaded shanks. See page 9customers specications of A, B, O, P, J, K, for Threaded Shank Selection Chart.L, F or W, etc. 4. Die sets of design other than shown in cata-2. All die sets are always made so that the log can be furnished in steel or aluminum.punch holder can not be reversed on die 5. Custom die sets may not be returned forholder. Type 4Ps are made with same credit.diameter posts, but the right front post isoffset 1/8 toward outside edge of die set. 6. Sintered Bronze Bushings supplied unless3. Any of these sets are available both with or otherwise specied.without shank. Unless otherwise specied,Four Post Die Sets These dimensions apply to both two post andDimensions furnished when customer species only A and four post sets.B dimensions.NominalGuide Post C FDiameter3/41 1/ 4 1 5/81 1 1/2 21 1/41 5/ 8 2 1/ 41 1/21 3/ 4 2 1/ 21 3/41 7/8 2 3/42 2 32 1/22 1/ 2 3 3/43 2 3/4 4 1/4Let Us Quote Your Special Applications Aluminum die sets. Three and four platen die sets. Plate work, ground or unground. Stress relieved plates. Die sets can be made with heel blocks. Per print CNC machining, holes, keyways, cutouts and burnouts.5'